Skip to content

2-year workmanship warranty. Free consultation

(843) 919-4905
(843) 919-4905

ServicesGutter Installation

Gutter Installation in Meggett, SC

We take down gutters that sag, leak or rust, fix what they hang from, and put up new ones sized for your roof. You get a written estimate, a clean yard and a walk-through before we leave.

Two installers on stepladders lift a long white seamless gutter section against the fascia of a single-story brick house, with gutter stock staged nearby

New gutters, hung the way we'd want on our own house

Gutter installation is the whole job. We remove the old runs, check the fascia board behind them, and hang new gutters sized for how much water your roof sheds. Done right, rain leaves the roof edge and heads away from your siding, windows and foundation instead of pouring down them.

It's the right call when the old system is past patching. If the same sections keep sagging or dripping after a couple of fixes, new gutters usually cost less over time than the next repair. If yours are still sound, we'll tell you that and send you to our gutter repair service instead.

We treat your place like a neighbor's. We show up when we say we will, keep the mess off your lawn, and explain what we're doing in plain words.

What the job includes

Old gutters out and hauled away

We take down the old gutters, pull the old spikes and hangers, and haul it all off. Nothing gets left behind in your flower beds.

A look at the fascia

Once the old gutters are off, we check the board they hung from. Soft or rotted wood won't hold a screw. We take photos of what we find and talk it over with you before any extra work.

Sized for your roof

We measure roof area and pitch, then choose between 5-inch and 6-inch gutters. Steep roofs and valleys dump a lot of water in one spot, and an undersized gutter overflows in a hard rain.

The right slope

Each run gets a slight fall toward its outlet, about a quarter inch every ten feet. Too flat and water sits and stains. Too steep and it looks crooked from the street.

Hidden hangers, set close

We screw hidden hangers into solid wood, spaced close enough to carry wet leaves and a full load of water without bowing.

Cleanup and a water test

We pick up scraps and loose screws and sweep the yard with a magnet. Then we run a hose down the gutters so you can watch the water go where it should.

Installer on an aluminum ladder pointing to a rusted gutter seam on a brick ranch house while the homeowner watches from below

Signs it's time for new gutters

Sagging or pulling away
A gutter that dips in the middle or leans off the roof edge has lost its grip. Usually the hangers have failed, the wood behind them has, or both.
Water going over the front
If rain sheets over the edge during a storm, the gutter may be too small, sloped wrong, or bent out of shape.
Rust, holes and split ends
Old steel gutters rust through, and end caps work loose. Once rust spreads along a run, patching it is money spent on metal that's already done.
Stains and peeling paint below the roofline
Dark streaks on siding or paint peeling off the fascia mean water is running where it shouldn't. Left alone, that turns into rotted wood.
Puddles and washed-out soil by the foundation
Our summer storms drop a lot of rain fast. If you see trenches in the mulch or standing water against your home afterward, the gutters aren't moving water away.

How a gutter installation goes

  1. 1

    Free consultation at your home

    We come out, walk the roofline, take measurements and talk through material and color. Then we write up an estimate that breaks out removal, materials, labor and any wood repair, so you can see where every dollar goes.

  2. 2

    Pick a day

    We set a date that works for you. Many single-story homes take about a day. Bigger or two-story homes can take longer, and we'll tell you what to expect at the estimate.

  3. 3

    Install day

    We set ladders with stand-offs so they don't dent anything and keep tools off your plantings. Old gutters come down, any bad wood gets handled as agreed, and the new runs go up.

  4. 4

    Test and walk-through

    We run water through every run, clean up, and walk the job with you. If something doesn't look right to you, we fix it before we pack up.

What sets the price

We price each job after seeing the house, because no two rooflines are the same. Your written estimate spells out what you're paying for. If we find something unexpected, like rotted fascia, we show you and talk it through before doing any extra work.

Length and corners
More feet of roofline means more gutter. Every inside and outside corner adds cutting, sealing and time.
Material
Aluminum is the most common choice and holds up well. Copper and steel cost more for the material and take more work to cut and join.
Height and access
A two-story wall, a steep yard or a deck under the eaves means more ladder work and more setup.
Condition of the wood
Sound fascia is ready for new hangers. Rotted boards have to come out and be replaced before anything hangs from them, and we price that wood work apart from the gutters so you can see exactly what it adds.
Gutter size and add-ons
Six-inch gutters cost a bit more than five-inch. Adding gutter guards or gutter covers during the install also changes the total.

Gutter installation questions

What gutter material should I choose?
For most homes we recommend aluminum. It's light, doesn't rust, and comes in a lot of colors. Near the coast, salt air is hard on plain steel, so we steer people away from it. Copper costs more but lasts a long time and looks good on older or higher-end homes.
Can you match my trim color?
Usually, yes. Aluminum gutters come in a wide range of factory colors. We bring samples to the consultation so you can hold them up against your trim and pick in daylight.
Should I add gutter guards while you're installing?
It's often the easiest time to do it, since the gutters are new and we're already on the ladder. Guards cut down on leaves and pine straw building up. We'll go over gutter guards and gutter covers with you and tell you honestly if your yard needs them.
Do I need a permit for new gutters?
Replacing gutters on a house usually doesn't need a building permit, but rules can differ by town and some neighborhoods have HOA guidelines on color. We'll check what applies to your address before we start and let you know.
Can I use a rain chain instead of a standard drain at one corner?
Yes. A rain chain hangs from the gutter outlet and guides water down to the ground, and it looks nice by a porch or entry. We can plan for it during the install. Our Rain Chains page has more on how they work.
Brown seamless gutter and downspout with offset elbows on a tan stucco home, draining onto a splash block in river-rock landscaping beside a covered patio

Let's take a look at your roofline

We'll come out, measure, and tell you straight whether you need new gutters or just a fix. You'll have a written estimate in hand before any work is scheduled.